Cycle Pro Moped Kits & Parts

Throttle Cable

SUits all Cycle Pro engine models,

This is the new Phantom 85 V3 - the latest model Phantom 85 engine kit!

Introducing the ZTMOTO Phantom 85. The first true 85cc 2 stroke engine built for motorized bicycling. The new Phantom 85 engine has been redesigned ...

Dual Brake Lever.

The dual brake lever can be used for operating both front and rear brake with the smae lever, so the left hand lever can be used for the clutch

CPM Chain

Chain pitch: 415

Complete with joiner link

Suitable for all Cycle Pro engine kits

Length: 300mm

This pipe consists of a manifold that bolts to the cylinder as normal. The main pipe has a screw coupling that screws to the manifold. You can swivel the pipe/manifold at the coupling to get the right angle etc.

This pip...

Clutch Cam Lever

Suits all engine models

Exhaust / Muffler

Suits the Phantom 85 engines.

This is the throttle control handle with the on/off button attached.

Comes complete with the left hand side matching grip

Cycle Pro Front Sprocket

Suits all models of Cycle Pro engines

Clutch Rod Ball (8mm)

This is the primary ignition coil.
Fits all models.

Clutch Handle

Suits all Cycle Pro models

Cycle Pro Clutch Cable

Complete with springs and cable clamp

Head Gasket

Suits 70cc engines

Cylinder Stud

Suits 50cc and 60cc engine

Idle Adjuster Screw & Spring - NT Carburettor

Suits NT and NT-Speed carburettors

Half Link

Sometimes a half link is required to archive the correct chain tension when there's no enough adjustment.

Suits 415 chains.

Air Filter Assy

Suits engines with CNS-R Carburettor

Set of clutch pads

Comes as set of 15 pads

Suitable for all Cycle Pro engines

This kit comes with the cylinder, piston, piston rings, cylinder head, studs, gaskets etc.

Suits Road 70, Street 70 and Speed 70 engines

CPM Performance Cylinder Head

This is a high compression cylinder head machine from a solid billet of aluminum.

Fitting this cylinder kit to an standard 70cc Cycle Pro engine gives a huge compression increase whic...

Dual Brake Lever

The dual brake lever can be used for operating both front and rear brake with the same lever, so the left hand lever can be used for the clutch.

This handle has individual cable adjuster so you ca...

Intake Gasket.

This is the gasket that fits between the cylinder and the reed valve manifolds for the Phantom 85 engines.

Exhaust / Muffler Gasket

Suits the Phantom 85 engines

Cycle Pro XT 80 (80cc) Bicycle Engine Kit

All new 80cc engine kit from Cycle Pro!

These are the latest engines. All our new engines have high quality CNC machined engine housings, stronger engine mounts, a new hig...

Cylinder & Piston Kit

Complete with cylinder, piston, piston rings, gudgeon pin and clips.

Suits the Phantom 85 engine.

This is the new V3 cylinder kit.